Hunter Fan 23347 Fan User Manual


  Open as PDF
of 12
 
5
42832-01•06/04/08•HunterFanCompany
CAUTION: Toavoidpossibleelectricalshock,beforeinstallingyourfan,
disconnect the power by turning off the circuit breakers to the outlet box
and associated wall switch location. If you cannot lock the circuit breakers
in the off position, securely fasten a prominent warning device, such as a
tag, to the service panel.
2-1. Drill two pilot holes into the wood support structure through the
outermostholesintheoutletbox.epilotholesshouldbe9/64”
in diameter.
2-2. Partially install two canopy screws in the holes on each end of the
hanger bracket, as shown in the figure to the right.
2-3. Your fan comes with four mounting isolators. Position the
isolators between the hanger bracket and ceiling by inserting the
raised areas on each isolator into the holes in the hanger bracket.
2-4. read the lead wires from the outlet box down through the hole
in the middle of the hanger bracket.
2-5. Aligntheslottedholesinthehangerbracketwiththepilotholes
you drilled in the wood support structure.
Note: e isolators should be flush against the ceiling.
2-6. Placeaatwasheroneachofthetwo3”woodscrewsandpass
the screws through the slotted holes in the hanger bracket into
the pilot holes you drilled.
Tightenthescrewsintothe9/64”pilotholes;donotuselubricants
on the screws. Do not over tighten.
Step 2-2
Flat Washer
3”WoodScrew
Steps 2-4 – 2-6
Hanger
Bracket
Step 2-3
Canopy Screw
Canopy
Screw
Isolator
2 • Installing the Hanger Bracket
 previous next