H-P Products Electroglide Vacuum Cleaner User Manual


 
10 ELECTROGLIDE
Belt Removal (continued)
6. Remove worn belt.
7. Slide brush supports off to
check and clean brush support
areas.
MAINTENANCE AND CARE
To replace belt:
1. Slide washers and brush
supports onto brush assembly.
2. Install new belt over motor
drive, then over brush sprocket.
3. Snap brush supports into place
on base. Be sure brush supports
are not upside-down.
4. Line up front of cover and base.
Rest cover on front edge of
base as shown.
Brush
Support
Brush
Motor
Drive
Brush Sprocket
Cover
Base