Filter
Top Products
1. Press swing up and down button continuously more than 2s,the main unit will swing back
and forth from up to down, and then loosen the button, the unit will stop swinging and present
position of guide louver will be kept immediately.
2. Under swing up and down mode, when the status is switched from off to , if press this
button again 2s later, status will switch to off status directly; if press this button again
within 2s,the change of swing status will also depend on the circulation sequence stated above.
About switch between Fahrenheit and Centigrade
Under status of unit off, press MODE and - buttons simultaneously to switch℃ and ℉.
It indicates: after starting this function by remote controller and the unit has been under
defrost status, If
you turn off the unit by remote controller, the unit will not stop defrosting until
it is finished; if chang
ing the setting mode by remote controller, the function ,which is set last
time, won't be carried out until defrosting
is finished.
Operation of this function on or off: If remote controller is under off status, press mode button
rednu si tinu eht fI .noitcnuf wen siht lecnac ro retne ot redro ni ylsuoenatlumis nottub wolb dna
defrost mode, dual eight position on remote controller will display H1.If switch to heat mode,
the position will display H1, which flickers for 5s, in which case, press MODE/- button, H1 will
disappear and setting temp. be displayed.
After remote controller is powered on, the new defrost function will be defaulted to be closed.
★
★
★
About swing up and down
About new function of defrosting
1.
4.
2.
3.
★
●
●
●
●
●
Slightly press the place with , along the arrowhead direction to push the back cover of wireless
remotecontrol. (As show in figure)
Take out the old batteries. (As show in figure)
Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
(As show in figure)
Attach the back cover of wireless remote control. (As show in figure)
When changing the batteries, do not use the old or different batteries,
If the wireless remote control will not be used for a long time, please
otherwise, it can cause the malfunction of the wireless remote control.
take them out, and don't let the leakage liquid damage the wireless
remote control.
The operation should be in its receiving range.
It should be placed
1m away from the TV set or stereo sound sets.
If the wireless remote control can not operate normally, please take them out,
after 30s later and reinsert, if they cannot normally run, please change them.
Sketch map for
changing batteries
NOTE:
Changing batteries and notices
12