Filter
Top Products
Replacing bag door
Reposition bag door by placing tab on
bottom of door into opening (C).
Press top of door to snap securely shut.
Secondary and final filters
Cleaning secondary
filter
Disconnect cleaner from electrical
outlet.
The
secondary filter (A),
located
behind the grill in the bottom of bag
compartment, protects the motor from
dirt particles.
If filter becomes dirty, pull off grill and lift
out filter,
Hand wash filter in cold water with mild
detergent, then air dry.
Reposition dry filter and grill.
Should you want to replace this filter,
ask for HOOVER
part No. 38765019.
Replacing final filter
The final filter assists in the filtration
process to return clean air to the room.
The pleated filter will become dirty and
needs to be replaced about once a year
to maintain efficient filtration. The 3 layer
filter (some models) can be washed in
the same manner as the secondary filter
and reused.
To remove final filter, first open the door
on the side of the cleaner (Fig. 3-6).
Grasp filter (B) and pull it straight out.
Reposition new filter by reversing this
procedure.
The final filter can be replaced with any
of the following filters.
3 layer, washable
-
HOOVER
part No.
40110006
HEPA
filter HOOVER
part No. 43613022
Do not operate cleaner without both
the secondary and final filter in place.
How to reattach filter
door
The filter door is designed with a “break-
away” feature which allows it to snap
free if it is pushed open too far.
To reattach, align hinges (C) of cover
with slots on sides of filter area.
Press door back into place.
Check brush roll
charm=
nels
Because your WindTunnel”cleaner picks
up so well, we strongly recommend you
check for debris accumulation in the
channels next to the brush roll when
you check the filters.
Removing this
debris will help maintain you cleaner’s
excellent pick up and suction. Remove
debris as follows:
Disconnect cleaner from electrical
outlet.
Check for debris accumulation by
removing bottom plate (Fig. 3-9) and
looking in the channels next to the brush
roll (Fig. 3-18).
Remove any accumulation.
Reposition bottom plate (Fig. 3-13).
lii;flight
replace-
What to buy
This cleaner uses a 12 volt, wedge base
type 912 bulb, Hoover
part No.
27313101.
Removing lens
Disconnect cleaner from electrical
outlet.
Using a Phillips screwdriver, remove the
two screws as shown and lift off lens.
Continued
e
9