Filter
Top Products
7
Drywall dust
For best results when picking up dry
wall dust, slide wet/dry selector (A)
to expose “WET/TANK INLET” (B)
and make sure no water or moisture
is in the tank (outer tank).
Keep inner tank in position.
Insert hose into “WET TANK INLET”
and attach desired tool to hose end.
Portable blower
The blower can be used to blow dirt
out of areas where it is impossible
for suction to reach.
Disconnect cleaner from
electrical outlet.
Inside of wand and tools must be
free of litter before operating
blower.
Removing blower
Rotate blower latches (A) to release
blower. Lift blower off lid (B).
NOTE: Do not use blower handle
to lift or carry assembled cleaner
while blower is attached to cleaner
lid.
Attaching tools to
blower
Attach a 2 1/2-inch wand and blower
nozzle.
Plug cord into a properly grounded
outlet and turn blower on.
To reposition blower, disconnect
blower from electrical outlet.
Remove wand;position blower on
top of lid and secure latches.
CAUTION: Wear safety goggles
when using blower. Do not blow
toward people, animals, or objects
that may be damaged by flying
debris.
Do not wear loose clothing or
jewelry. Secure loose hair with a hat
or hair net. Wear substantial
footwear and long pants.
Wear ear protection if using the
blower for a prolonged period
of time.
Do not use blower in wet or rainy
conditions.
Turn blower off before setting
it down.
Storage
Empty tanks (see “Maintenance”
section). Rinse inside of tank
thoroughly with clean water
particularly if spills or other liquid
substances other than plain water
have been picked up. Wipe inside
of tank dry.
Loop cord over cord storage hook,
located on tool rack.
Wands store on rear caster
supports. The larger diameter
wands fit into outer triangle, the
smaller diameter wands store inside
the larger wands and over small
triangular peg.
Tools store on tool rack as shown.
2-6
2-5
2-7
2-8
A
A
B
B