If you have a problem
This appliance was inspected thoroughly and was in good operating con-
dition when it was shipped from the factory. If a minor problem devel-
ops, it usually can be remedied quite easily when the cause is identified.
Accordingly, this check list is provided for your convenience.
Problem Possible cause
Possible solution
Cleaner
1.
Not firmly plugged in.
1. Plug unit in firmly.
won’t
2. No voltage in wall plug.
2. Check fuse or breaker.
run
3. Blown fuse/tripped
3. Replace fuse/reset
breaker.
breaker.
Cleaner
1. Broken or worn belt 1. Replace belt.
won’t
2. Agitator brushes worn.
2. Replace brushes.
pick up 3. Bag full.
3. Change throw away
bag.
4. Incorrect carpet adjust-
4. Set carpet adjustment
ment lever setting.
lever for type carpet
being cleaned,
Cleaner
1. Incorrect carpet adjust-
1. Set carpet adjustment
hard
ment lever setting.
lever for type carpet
to push
being cleaned.
2. Belt on incorrectly.
2. Position belt correctly
(See page 19, #5).
If the problem persists, check the Yellow Pages of your telephone
book under “Vacuum Cleaners
-
Household” for your nearest Hoover
Factory Service Center or Authorized Warranty Service Dealer where
approved HOOVER service and genuine HOOVER replacement parts
may be obtained. The warranty provided with this product has a listing
of the Hoover Factory Service Centers. If you are unable to obtain the in-
formation you need from the Yellow Pages, contact a Hoover Factory
Service Center to find your nearest Authorized Warranty Service Dealer.
For service under warranty, follow the instructions in the Warranty pro-
vided with this product.
DO not send your cleaner to The Hoover Company in North Canton for
service as this will only result in delay.
Always identify your cleaner by model number when requesting informa-
tion or ordering replacement parts. (The model number appears on the
bottom of the cleaner.)
If further assistance is needed, contact The Hoover Company Con-
sumer Affairs Department, North Canton, Ohio
44720,216-499-9200.