Filter
Top Products
C. Attach tool
After choosing the proper tool for
your particular task, attach it to
the end of the hose grip.
The outer plastic ring on the end
of the hose grip has a slot.
Turn the ring until that slot aligns
with the slot in the hose connec-
tor.
Insert the tool so that the button
on the tool fits into the slot in the
end of the hose grip.
Turn the plastic ring as shown to
lock the tool in place. To remove
tools, reverse the procedure.
For additional length, attach one
or both* wands to the hose as
described above.
Tools attach to the
wand(s*)
in
the same manner.
*Available with deluxe set only.
D. Use correct handle position and carpet
height adjustment
Some models are equipped with a second motor speed for use with
toolsWhen
the handle is placed in the upright storage position,the
motor automatically adjusts to the higher speed.
For added stability, the carpet height adjustment lever should be set ac-
cording to the surface on which the cleaner is standing: on bare floors,
set at LOW setting; on carpet, set at SHAG setting.
For tool use place the cleaner handle in the upright position, plug
cleaner into the electrical outlet and push switch to the “ON” or “NOR-
MAL” position. Your cleaner is ready for use for cleaning above the floor
and in hard to reach areas.
To clean tools
To clean the hose wipe off dirt with a cloth dampened with a liquid deter-
gent. Rinse with a damp cloth. Cleaning tools may be washed in warm
water with a detergent, Rinse and let dry before using.
15