Filter
Top Products
5
connector straight in until you hear a
click. Return battery pack and termi-
nal into unit.
Replace battery door by first insert-
ing tab (F) on bottom of door and
positioning hole (G) on door with
hole (H) on unit. Replace screw and
tighten with screwdriver
14
Dispose of battery pack in accor-
dance with your state’s laws.
The EPA certified RBRC
®
Battery
Recycling Seal on the nickel-cadmi-
um (Ni-Cd) battery indicates The
Hoover Company is voluntarily par-
ticipating in an industry program to
collect and recycle these batteries
at the end of their useful life, when
taken out of service in the United
States or Canada. The RBRC
®
pro-
gram provides a convenient alterna-
tive to placing used Ni-Cad batter-
ies into the trash or the municipal
waste stream, which may be illegal
in your area. Please call 1-800-8-
BATTERY
™
for information on Ni-Cd
battery recycling and disposal
bans/restrictions in your area.
The Hoover Company’s involvement
in this program is part of our com-
mitment to preserving our environ-
ment and conserving our natural
resources.
To obtain approved Hoover Service
and Genuine HOOVER parts, locate
the nearest Hoover Factory Service
Center or Authorized Hoover
Warranty Service Dealer (Depot) by:
• checking the Yellow Pages
under “Vacuum Cleaners-
Household” OR -
• checking the list of Factory
Service Centers provided with
this cleaner OR -
• checking the Service section of
The Hoover Company on-line at
www.hoover.com OR -
• calling 1-800-944-9200 for an
automated referral of authorized
service outlet location (U.S. only).
Do not send your cleaner to The
Hoover Company in North Canton
for service, this will only result in
delay.
If further assistance is needed, con-
tact The Hoover Company
Consumer Response Center, North
Canton, Ohio 44720,
Phone: 1-330-499-9499.
In Canada, contact Hoover Canada,
Burlington, Ontario L7R 4A8,
Phone: 1-800-263-6376.
Always identify your cleaner by the
complete model number when
requesting information or ordering
parts. (The model number appears
on the bottom of the cleaner.)
Service
Lubrication
Lubrication is not necessary since
the motor and brush roll bearings
are permanently lubricated.
If desired, you may contact your
local Hoover Factory Service Center
for battery pack replacement.
If you have a
problem
If a minor problem occurs, it usually
can be solved quite easily when the
cause is found by using the check
list below.
Possible Cause
Possible solution
• Charger not firmly plugged in
• Plug charger in firmly
• Battery not charged
• Recharge battery making sure
cleaner is fully connected to end
of cord
• No voltage in wall plug
Problem: Cleaner won’t run
Problem: Cleaner won’t pick up
Problem: Charging light not lit
when plugged in
Possible Cause
Possible solution
• Cleaner not firmly plugged in
• Plug charger in firmly
• Check fuse or breaker
• Blown fuse or tripped breaker
• Replace fuse/ reset breaker
F
G
H