Filter
Top Products
4
Push middle section of filter back
into filter frame. Replace filter into
dirt cup.
Replace dirt cup to cleaner by sit-
ting cup into dirt cup cavity with the
black flap (A) on the dirt inlet facing
the front of the unit. Then pivot the
dirt cup forward until a snap is felt.
Lock in place by sliding the latch (B)
toward the center of the nozzle.
The brush roll
How to clean
Turn switch to OFF position.
To maintain cleaning effectiveness,
periodically remove lint, strings, etc.
from the brush roll (A) located on the
underneath side of the nozzle.
When to replace
Replace the brush roll when the
brushes do not touch the edge of a
card as it is moved across the open-
ing on the bottom of the nozzle.
A new brush roll can be installed by
your local Authorized Hoover Dealer
(Depot) or at a Hoover Factory Service
Center.
Battery recycling
Your cleaner contains nickel cadmi-
um batteries.
When these batteries no longer
recharge, they must be removed
from the cleaner and disposed of
properly in accordance with state
laws as described in Item 14.
How to remove battery
pack
NOTE: Do not remove the batteries
to recharge them. The batteries
should only be removed if they no
longer recharge and you plan to
replace the batteries or dispose of
the cleaner.
Using a Phillips screwdriver, remove
screw (A) on battery door (B).
Remove door.
Remove battery pack (C) from unit.
To disconnect battery pack from ter-
minal, push down on tab (D) and
pull connector (E) straight out.
To install a new battery pack, push
8 9
10
11
12
13
Storage
The cleaner may be conveniently
hung from the hook (A) located on
the top of the upper handle.
Turn switch to OFF position before
hanging.
A
A
E
D
C
A
B
A
B