Filter
Top Products
3
NORTH CANTON FOR SERVICE.
5
6
43
How to assemble
Attach handle
With upper handle button (A)
towards back of cleaner, push
Charging
How to use
upper handle (B) into lower handle
(C) until button snaps into position.
With switch (A) in OFF position, plug
charger (B) into 110/120 volt electri-
cal outlet.
Firmly press charger end into clean-
er receptacle (C), located on the
side of the handle. Press firmly on
cleaner to ensure that end of cord
is fully connected. Your cleaner will
begin charging. It is designed to be
stored on charge and ready for use
at all times.
Charge batteries for 16 hours
before initial use. If performance
drops to an unacceptable level dur-
ing cleaning, refer to the problem
chart in “Maintenance” section.
NOTE:
• It is normal for the charger to feel
warm when the battery is charging.
Never charge batteries in tempera-
tures above100
o
F or below 32
o
F.
• Charging light illuminates when
cleaner is charging.
• The cleaner can be on a constant
charge so it is always ready for use.
Make sure it is in OFF position
before charging. However, if the
cleaner will not be used for several
weeks at a time, unplugging it is
recommended.
Do not use an outlet which is con-
trolled with a wall switch for
charging your cleaner.
ON-OFF switch
The switch has 2 positions.
Push switch (A) down to ON position
and lower handle to operating posi-
tion to turn the unit on. For conve-
nience, the unit will stop running
when the handle is placed in the
upright position.
When cleaning is finished, it is rec-
ommended that the switch be turned
to the OFF position for storage.
Familiarize yourself with these home
maintenance tasks as proper use
and care of your cleaner will ensure
continued cleaning effectiveness.
The dirt cup
Empty dirt cup after each use. It
Maintenance
may be cleaned with a damp cloth.
Make sure cup is thoroughly dry
before repositioning on cleaner.
How to empty
Turn switch to OFF position.
Press button (A) and slide latch (B)
towards outside of cleaner. Rotate
dirt cup (C) toward back of cleaner.
While holding dirt cup (A), grasp fil-
ter frame (B) and lift out filter.
Empty dirt cup.
Pull middle section (C) of filter out of
filter frame. To remove debris from
filter, tap it on a hard surface or
brush it with a soft brush.
7
B
A
C
B
A
A
C
B
C
C
B
A
A