Filter
Top Products
Assembly
1. Remove tank from shampoo-
polisher and remove nut, bolt and
cord clip from top of lower han-
dle section.
2. Join upper and lower handles,
lining up holes. Place cord clip
around cord with flat side toward
handle and holes to front.
3. Insert bolt through cord clip,
and through small holes of han-
dle; secure with nut. Pull up slack
in cord and tighten nut with
screwdriver.
How to use
The shampoo-polisher’s
ON-
OFF switch is internal and is
operated by lowering and rais-
ing the handle. Be sure handle is
in lock (upright) position before
connecting power cord to wall
outlet.
Start shampoo-polisher by press-
ing handle release lever and
lowering handle. Raise handle to
lock position to stop shampoo-
polisher.
To attach and
remove brushes
and pads
Disconnect from electric circuit
kWrheMputting
on or removing
.
Place shampoo-polisher upside
down on flat surface.
5
To attach brushes press each
brush down firmly over brush
shaft, rotating brush until it clicks
into position. To remove -grasp
center of brush with thumb and
fingers and lift up.