Filter
Top Products
.
.
foam. Crisscross area to work
foam uniformly into the carpet
(see illustration) until the foam
disappears. The final strokes over
each area should always be in the
same direction.
Repeat the process over another 3 ft. x 3 ft. area
(Im
x Im), overlapping
the areas bv several inches. Continue until a 3 ft. (Im)
length the width of
the carpet or rug has been cleaned.
4. Brush pile
Brush pile in one direction with a
long-handled brush, This speeds
the drying and gives a uniform
appearance. Use a forward and
backward stroke. After determin-
ing which direction looks best,
the last strokes should be in the
same direction on all areas of the
carpet. Repeat the process of
shampooing and brushing until
the entire carpet or rug has been
cleaned.
5. Allow carpet to dry
The length of time for drying varies; however, overnight drying is
desirable whenever possible. The use of an electric fan to speed drying is
helpful. If it is necessary to walk on the carpet before it is dry, place
towels or white cloths on the traffic areas. If furniture must be replaced
before the carpet is dry, use plastic or aluminum foil pads under legs
of furniture so metal slides or wood finishes will not stain the carpet
or rug.
6. Vacuum dry carpet
Vacuum area thoroughly after it is dry to remove the dry detergent
and the dirt loosened by the cleaning process. Frequent vacuuming
during the first week after shampooing will enhance the appearance of
the carpet.
Drydeaning
carpet
The shampoo-polisher may be used to work dry-cleaning compounds or
powders into carpet or rugs. Do not put these substances into the tank
and be sure shampoo brushes are dry. Test a small area of carpet for col-
orfastness by sprinkling a small amount of powder and wiping with a
white cloth. Then check for texture change by using shampoo-polisher
with dry brushes in the same area. If color and texture are not affected,
follow directions on container for amounts to use and drying time. After
compound has dried, vacuum area thoroughly. Install a new disposable
bag in vacuum cleaner to insure complete removal of cleaning com-
pound and dirt. Frequent bag changes may be necessary when a
powdered dry-cleaning compound is used.
10