Support User Manuals

Hoover S3825 Vacuum Cleaner User Manual

Open as PDF

of 17

Cleaning the Cyclone

Separator

Step I

Twist lid

to

the

unlock

position

and

pull

the dirt con-

tainer bin off the

cyclonic separator.

Step

ll

The separator

should

be cleaned

with a soft brush

and wiped

with a

damp cloth.

The

dirt container

bin

may be wiped

to

clean.

Step

lll

Leave the

separator

to

dry completely

before

replacing.

IMPORTANT:

The

cyclonic

separator

should

not be

sub-

merged

in

water

Step

lV

Replace the

dirt

container

as direct-

ed,

by twisting

lid

to

the

locked

pos-

tion.

Cleaning

the

Pre-Motor

Filter

NOTE: This is located

underneath

the dirt

container bin.

Step

I

Release the

pre-

motor filter

cover

by

lifting

up the

tab.

Lift

off the

filter

cover to

gain

access to the

filter.

Remove the filter

by

pulling

the

tab

towards

you.

Step

ll

Separate the

foam

filter

from

the

fab-

ric cassette.

Each

filter can be tapped

against the side

of

a

trash

can to

remove the excess

dirt and dust.

Step

lll

The

pre-motor

filter may be

rinsed in warm

water.

Allow to air

dry

for 24 hours

before

replacing.

NOTE: Do not

use

any

detergents or

boiling

water to

wash the

filters.

For

best

perfor-

mance, the foam

filter

should

be

cleaned each

time

the dirt container is

emptied.

Step

lV

0nce completely

dry, return

the

pre-motor

filter

and cassette to the

vacuum cleaner.

Replace

the

pre-

motor filter

cover

before

restarting

the vacuum cleaner.

previous next