Filter
Top Products
MOTOR
PULLEY
AGITATOR
PULLEY
PR‘OJECTION
SiOT
I
Return nozzle to original position
and lift up back of nozzle cover.
Then remove cover, rotating it
forward and lifting it off.
To remove the agitator, position
your hand underneath the nozzle
base at the agitator opening and
push up the belt end of the agita-
tor. Remove agitator and old belt.
Place one end of new belt around
the plastic agitator pulley, with
lettering on outside of belt.
Then slip other end of belt around
motor pulley.
Position round projection on end
of agitator (opposite the belt) into
the opening in the wall of the
nozzle base.
Slide belt end of agitator into
place by pulling agitator forward
and lining up metal projection on
end of agitator with slot in wall of
nozzle base. Then push agitator
down into position.
Roll agitator to make sure belt is
positioned properly.
16