Hoover Commercial Spotter/Carpet Cleaner Vacuum Cleaner User Manual


 
6
2-11
2-12
2-13
2-14
2-15
2-16
2-17
Carry tank to a sink.
Rotate tank cap counterclockwise and
lift up to remove cap.
Turn cap (H) upside down to serve as a
measuring cup.
H
I
Using cap, measure detergent following
the chart:
For carpet,
Fill cap to fill line (I) (5 ounces) with
HOOVER Carpet/Upholstery Detergent.
Do not use any type of wax with your
‘SteamVac’ cleaner.
To assure proper performance, it is rec-
ommended that only HOOVER detergent
be used. It is specifically formulated for
use with the cleaner.
CAUTION: Detergents contain Anionic
and Nonionic Surfactants. Avoid con-
tact with eyes and skin. In case of
contact with eyes, flush with cold
water for 15 minutes. In case of con-
tact with skin, wash with water. If irri-
tation persists, call a physician. For
medical information (U.S.)
call 1-800-752-7869.
Pour detergent into tank.
Fill tank to fill line (J) (1 gallon ) with hot
tap water.
.
J
K
L
If rubber ring (K) on cap has displaced,
replace it with uneven side against cap
ledge (L) as shown.
Replace cap. Rotate cap clockwise
until it locks in place. Cap must be
locked in place for proper perfor-
mance and to prevent leaking.
Position bottom of tank into unit and
press on tank handle to snap tank into
place.
Recovery tank
(lower tank)
The recovery tank holds the dirty solu-
tion that is picked up from the carpet.
When the recovery tank is full, the auto-
matic “shut-off” will engage (see page 5)
and the tank must be emptied.
How to empty
Turn cleaner off and disconnect from
electrical outlet.
To prevent possible leaking, remove
clean solution tank by pressing down on
tank handle and pulling forward; set tank
aside (do not set tank on furniture).
Step on handle release pedal (M) and
lower handle until it rests on the floor.
Rotate recovery tank latches (N) outward
(one on each side of tank).
Lift tank off of cleaner and carry it to a
sink or drain.
N
M