Filter
Top Products
“CHECK BELT” light
The electronic power nozzle auto-
matically monitors its belt condi-
tion. When the belt needs replac-
ed, the red “CHECK BELT” light
will come “ON” and remain
“ON” until the belt is replaced.
To replace belt, refer to “The
belt” section under Maintenance.
“POWER GUARD”
feature
The electronic power nozzle has
a unique feature which warns of
motor overload conditions. The
red “POWER GUARD” light will
come “ON” and the nozzle will
shut “OFF” if the motor is stalled
or if an agitator obstruction causes
a motor overload. Before remov-
ing any agitator obstructions or
opening the Suction Regulator
(see “Automatic nozzle adjust-
ment”), the CAUTION statement
below must be followed.
CAUTION: If the “POWER
GUARD” light is “ON”, the agi-
tator may suddenly start while you
are removing obstructions from
the agitator area. Therefore, turn
cleaner “OFF” and unplug before
cleaning or servicing. The elec-
tronic circuitry will be automati-
cally reset when the cleaner is
turned “OFF”.
Brushed edge cleaning
Brushed edge cleaning is provided
on both sides of the nozzle to re-
move imbedded dirt in carpet near
baseboards and furniture. Guide
either side of the nozzle parallel to
the edge of the carpet or furniture
as shown.
0
FLOOR
\
I
CARPET
\