Filter
Top Products
6
Both the worktop where the hob will be fitted and any adjacent kitchen furniture must be
made from heat resistant material and fixed with heat resistant adhesive.
If, when installing the hob, the lower hob face is adjacent to an area normally accessible
when handling or cleaning, fit a heatproof partition 1 cm below the base of the hob with
a 10X10 cm opening at the rear right-hand corner, to avoid any risk of scorching or damage.
A foam adhesive is supplied with the hob. Stick this seal under the edge of the body as
near as possible to the outer edge of the hob. Press round the edges of the hob, so that
the seal flattens out and ensures an air tight seal.
• BUILDING-IN
OPENING
10 X 10 cm
The body of the hob is fitted with 4 location holes to take the fixing brackets that secure
the hob in the unit. Place the 4 fixing brackets in such a way that the hob is placed
perfectly in the support unit.
SEAL
INSTALLATION : «BUILDING-IN»