Filter
Top Products
5
¤ = Factory setting: Natural gas = G20-20 mbar / G25-25 mbar
X = Gas setting possible according to installation Butane gas G30-29 mbar or Propane gas G 31-37 mbar
INSTALLATION: «GAS CONNECTION»
CHANGING THE JETS
To gain access to the jets, remove the pan supports,
and remove the burner cap and body,
Take a spanner and unscrew the jet.
According to the table below,
fit the correct jet for the
type of gas to be used,
Secure the jet tightly,
Replace the burner body, cap and the pan support.
JET
Each jet is designated by size.
SAG/ZAG 02G 52G03G13G
rabm02 rabm52rabm92
r
abm73
+3H2II.TACSE-TP-TI-BG
¤ XX
+3+E2II.TACRF
¤ ¤ XX
CHANGING THE GAS TYPE : the calorific power output and gas pressure will
vary according to the gas supply. Burner setting must be carried out once the gas and
electrical installation is complete.
When changing gas type, you must follow the procedure below :
. fit the correct jets,
. adjust the minimum flame on the taps.
SRENRUBBOH
yrailixuadipar-imesdipar
-artlu
dipar
sgniR4
saGrabmteJWkteJWkteJWkteJteJWk
* 02G 02 67 00,1 101 57,1 811 05,2 441 141 05,3
* 52G 52 67 09,0 101 06,1 811 03,2 441 141 02,3
03G920500,16657,10805,2496905,3
13G730500,16657,10805,2496905,3
* rabm52-52G-rabm02-02G:gnittesyrotcaF