Filter
Top Products
HOW TO REPLACE
THE BELT
1.
Remove cord from electrical outlet.
2.
Turn cleaner over. Remove metal
plate on bottom of cleaner by
pushing latches toward the out-
side of cleaner. Lift plate to re-
lease it from wire holders.
3,
Push latches, that hold agitator,
in and toward center of cleaner
until they are free. Lift out
agitator and remove old belt.
4. Place new belt over motor pulley,
with smooth side next to pulley,
then over agitator.
5. Replace agitator and latch it in
position.
6. Make sure that belt is in
cen,ter
of pulley and free of agitator
mountings and latch. Turn agitator
by hand to be sure that belt is in
proper position in pulley groove.
7.
Replace bottom plate. Place metal
knobs, on front of plate, in wire
holders, Check to see that. latches
are pushed back and will not be
covered by plate. Place plate in
position and latch securely.
Turn
agitator
by hand to be
sure
that
belt
is
in proper position on
puIIej’*
10