Filter
Top Products
- 8 -
If your cleaner is not picking up efciently, the belt or
brushes (or both) may need replacing, but rst make sure
you have:
• Emptied the dust container
• Cleaned lters
• Checked for blockages
Remove hood
• Prise off the carpet care control selector
• Remove hood screws A and B.
• Lift off hood
Remove brush assembly
• Inspect belt for signs of wear.
• To remove, pull brush cleaner assembly upwards out of
cleaner housing. Remove belt from motor spindle then
from brush assembly.
Replace belt
• Loop the new belt around the motor spindle then
around the brush channel.
Ret brush assembly
• Hold the brush assembly
and stretch the belt until
brush mountings slot down
into the cleaner housing.
Rotate the brush to ensure
free movement of the belt.
Ret hood
• Ret hood, ensuring the
lugs along the front of hood
are located in the slots
along the front edge of
baseplate.
• Secure hood, using screws
A and B.
Ret carpet care control
selector
• Ensure the raised face (T)
is towards the front of the
cleaner.
4
5
3
1
2
IMPORTANT: Switch cleaner off and
remove plug from electricity supply
before checking the brushes or removing
hood.
1
2
CHANGING BELT OR BRUSHES
This cleaner is unlikely to become blocked, except by
over lling of the dust container or accidentally picking
up large solid objects. Clearing a blockage is simple.
If cleaning tools were in use,
check cleaning tool and exten-
sion tube rst. Next check
hose handgrip; to remove grip
ribbed ring as shown, turn in
direction of arrow and ease
apart.
To check the hose, stretch it
to full length and switch on the
cleaner; the suction will dis-
lodge most obstructions. If this
is unsuccessful, switch off and
unplug the cleaner. Remove
the hose by turning it anti-
clockwise as shown. Detach
cassette and remove blockage.
For blockages in cleaner base:
1. Turn the cleaner over and
check that the brushes are
free to rotate.
2. Check for a blockage in
hose socket. Use a piece of
wire or a blunt exible rod
to remove any obstructions.
CLEARING A BLOCKAGE
IMPORTANT: Switch the cleaner
off and remove the plug from the
electricity supply before dismantling
cleaner.
!
- 8 -
* Features vary according to model
Removing a blockage from the
Pet Hair & Allergen Remover*
(Certain models only)
Open clip and lift cover to remove
blockage.
B
A
0565-5289.indd 8 28/11/2007 15:43:28