Filter
Top Products
- 10 -
®
User checklist
If your cleaner is not working properly run through the following checklist.
1 Is there a working electricity supply to the cleaner?
Check with another electrical product.
2. Is the dust container full or choked with ne dust?
To empty the dust container see the instructions on page 6.
3. Is the hose blocked?
To clear a blockage, see the instructions on page 8.
4. Is there a blockage in the cleaner base?
To clear a blockage, see the instructions on page 8.
5. Are the lters blocked?
To clear the lters, see the instructions on page 7.
6. Is the nozzle height set correctly?
To set the carpet care control selector, see the instructions on page 4.
7. Are the brushes rotating correctly?
To check the brushes, see the instructions on page 8.
8. Has the cleaner overheated? If so, it will take about 30 minutes to reset
itself.
If there is any doubt call the Hoover Service Ofce for advice. They may be
able to assist you over the telephone.
A service charge will be made if the cleaner is examined and found to be in
working order, has not been assembled in accordance with these instructions
or has been used incorrectly.
WARNING!
A thermal cut out switches off the cleaner to prevent overheating
if it is used when full or there is a blockage or dirty lters. If this
should happen switch off, unplug and correct the fault.
It will take about 30 minutes for the cut out to automatically
reset.
IMPORTANT: Do not run cleaner over the supply cord
as this could damage the supply cord insulation.
Hoover Limited
Pentrebach
Merthyr Tydl
Mid Glamorgan
CF48 4TU
© 2007
® Registered Trade Mark
* Features vary according to model
GENERATION FUTURE
0565-5289.indd 10 28/11/2007 15:43:29