Filter
Top Products
UV100RM TRUEUV™ COIL TREATMENT SYSTEM
3 68-0297EFS—05
When installing this product…
1. Read these instructions carefully. Failure to follow them
could damage the product or cause a hazardous
condition.
2. Check the rating given in the instructions and on the
product to make sure the product is suitable for your
application.
3. Installer must be a trained, experienced service
technician.
4. After installation is complete, check out product opera-
tion as provided in these instructions.
WARNING
UV Light Hazard.
Harmful to bare skin and eyes.
Can cause temporary or permanent loss of vision.
View illumination only through lamp light indicator on
lamp handle.
To prevent exposure to ultraviolet light, disconnect
power to ultraviolet system before servicing any part of
heating and air conditioning system.
Do not mount device in location that allows ultraviolet
light to be seen after installation.
CAUTION
Personal Injury Hazard.
Power supply can cause electrical shock.
Disconnect power supply before beginning installation.
Do not open ballast or lamp handle; there are no user-
serviceable components inside.
CAUTION
Equipment Damage Hazard.
Ultraviolet light can cause color shift or structural
degradation of plastic HVAC materials.
Select mounting location that prevents exposure to
plastic components with unknown resistance to
ultraviolet light. Three feet minimum is recommended
where there is direct exposure between ultraviolet lamp
and plastic-fabricated devices (such as humidifiers and
non-fiberglass media filters).
CAUTION
Sharp Edges Hazard.
Can cause personal injury.
Be careful when inserting ultraviolet device into sheet
metal cutout.
Wear protective gloves when working near sheet metal.
CAUTION
Breakable Glass Hazard.
Can cause personal injury.
Be careful when inserting bulb(s) into lamp base.
Wear protective gloves when handling bulb(s).
MERCURY NOTICE
This device contains mercury in the sealed ultraviolet
bulb(s). Do not place your used bulb(s) in the trash.
Dispose of properly.
Broken Bulb Cleanup.
Do not use a household vacuum.
Sweep debris into a plastic bag and dispose of
properly.
Contact your local waste management authority for
instructions regarding recycling and the proper disposal
of old bulb(s).
CAUTION
Bulb Burn Hazard.
Harmful to bare skin.
Can cause severe burns.
Disconnect power 15 minutes before removing
ultraviolet bulb(s).
INSTALLATION
Turn off power to air handler before installation.
Choose a location for duct-mounting the handle that will allow
maximum exposure to the coil, drain pans and internal
surfaces of the air handler. The adjustable mounting bracket
can be used to angle the bulb to fit in tight applications and to
maximize exposure. Ballast can be mounted in the control
panel of the air handler or outside of the duct when mounted in
a weather-protected space. Make sure to mount ballast within
reach of handle so 6-foot cord will reach.
Internal Mounting
For straight mounting, the handle can be mounted right on the
internal surface. Use self-tapping sheet metal screws to mount
the handle in the desired location.
Fig. 2. Direct mount to internal surface.
For angled mounting, adjust the mounting bracket to the
desired angle and fix in place with bolt. Use mounting screws
to mount the handle to the bracket. Use self-tapping sheet
metal screws to mount the bracket in the desired location.
M27055
SURFACE OF
AIR HANDLER