Filter
Top Products
11 63-2652—01
Using Temporary Occupied
Override
The Temporary Occupied Override can be used
when the T7350 is in Not Occupied or Standby
mode. It switches to the Occupied mode for a
fixed number of hours.
1. To use the default occupied override,
press Temporary Occupied.
NOTE: The default temperature setting
is the Occupied setpoint.
2. To select a temperature setting other than
the default, press up S or down T until
desired temperature offset displays
(range is configurable by the installer
from 0 to 5 °F (0 to 3 °C)).
Using Temporary Not Occupied
Override
The Temporary Not Occupied Override fixes the
device to operate in Not Occupied mode for a
number of days (between 1 and 99) without
changing the programming saved in memory.
NOTES:
— If the number of days is set to zero,
no temporary change takes effect.
— If the number of days is set just
below zero, the display for days is
“---” (an indefinite override).
— To turn off this override, you must
press Run Schedule.
1. Press Temporary Not Occupied.
2. Press up S or down T to change the
duration of the Not Occupied period (in
days).
63-2652_A.fm Page 11 Monday, May 10, 2010 4:21 PM