Filter
Top Products
15
MicroDock II
Charger Specifications
Charger Specifications
Size: 8.6 x 8.2 x 7.8 cm (3.4 x 3.2 x 3.1 in.)
Weight: 97 g (3.4 oz.) per model
Charger system ingress protection: IP20
Operating temperature: 10°C to 35°C (50°F to 95°F)
Humidity: 0 to 50%
Altitude: 2000 m (6561.66 ft.)
Power: 6 Vdc , 2.5 A
Charging LED: Color-coded LED indicates charging, charge
complete, and charger fault
Charge time: Typically 2-6 hours
Pollution Degree: 2
Installation Category: I
This device complies with the FCC Part 15 and ICES-003
Canadian EMI requirements. Operation is subject to the follow-
ing two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules and ICES-003 Canadian EMI requirements.
These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in
a commercial environment.
This equipment generates, uses, and can radiate radio fre-
quency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be
required to correct the interference at his/her own expense.
a
Warning
This product is designed for installation in an indoor
location only. All required National Electrical Codes and
Safety Standards must be followed.
For ac main installation, a circuit breaker should be
included in the building installation as a disconnect
device for the equipment. The disconnect device should
be installed in close proximity to the equipment and the
device should be marked as a disconnecting means for
the equipment.