Filter
Top Products
– 24 –
USER FUNCTIONS
“Follow Me” Announcement Feature
NOTES: (1) The “Follow Me” announcement will be terminated if any new report needs to be sent or if any key is
pressed on the LYNXR-I keypad or a wireless (RF) keypad. The [✻] key on a wireless keypad is
ignored by the system when the “Follow me” feature is active and cannot be used to terminate the
announcement or request status.
(2) If your LYNXR-I has been programmed to send “Follow Me” system messages upon
arming/disarming do not make any key strokes after you have disarmed the system (unless it is
necessary). Entering additional keystrokes will terminate the “Follow Me” message.
To program “Follow Me” reminder telephone number:
1. Enter:
+ FUNCTION + [65]
Master user code
2. The system will announce: “Enter follow me reminder phone number, press ADD to accept, press
ESCAPE to quit”.
NOTES: (1) The system will accept all digits including the star [✻], pound [#]. To insert a two (2) second pause
press the AUX
key.
(2) If the ESCAPE
key is pressed to cancel entry, the telephone number must be entered again.
(3) Pressing any key on a wireless (RF) keypad will terminate this mode and the “Follow Me” telephone
number must be reentered.
3. Enter up to 24 digits. After each digit is entered the system will announce the digit and it will be
displayed on the LCD screen. The system will not announce star, pound or pause, however “Str,
Pnd, or PAU will be displayed on the LCD screen.
4. After you have entered the last digit press
ADD to save the number. If 24 digits have been
entered the system will automatically save the number and exit the “Follow Me” announcement
feature.
NOTE: The “Follow me” reminder telephone number can be changed as often as necessary by repeating steps 1
through 4.
To delete “Follow Me” reminder telephone number
1. Enter:
+ FUNCTION + [65]
Master user code
2. The system will announce: “Enter follow me reminder phone number, press ADD to accept, press
ESCAPE to quit”.
3. Press ADD
without entering any digits.