Filter
Top Products
5
Setting the System — Part or Night Set
Part and Night setting are similar to Full setting but leave off certain detectors as agreed with
your installer. Additionally, the system can be programmed by the installer not to give any exit
timer tones during the setting period (silent set).
To Part or Night set:
Keypad:
Type your PIN code
then press [B].
Press [1] Part Set or
Press [2] Night Set.
5804 Keyfob:
Press the [Lower Left]
button (Part) or
Press the [Lower Right]
button (Night).
Prox Tag:
Use the keypad for
Part or
Night setting.
The tag will only Full
Set.
A 30 second exit timer will begin. Leave the protected area by the agreed route. A double
beep at the end of the exit time will confirm setting.
NOTE: Display not shown when
using wireless fobs to set
the system.
PART SET 030PART SET 030
PART SET 030PART SET 030
PART SET 030
Open ZoneOpen Zone
Open ZoneOpen Zone
Open Zone
1044 1044
1044 1044
1044
The setting procedure can be cancelled at any time during the exit time by pressing the esc key
on the keypad, the [OFF] button on the keyfob or placing the tag back in front of the prox
symbol.
NOTE: Display not shown when
using wireless keyfobs to set
the system.
If you hear a rapid beeping sound, the system cannot set as there are open zones. The keypad
will show which zones are open.
KTC805 Keyfob:
Press button 3 (Part
setting will com-
mence) or
press button 4 (night
setting will com-
mence)