Filter
Top Products
- 18 -
Miscellaneous Commands (cont)
CHANGE PARTITION (OMNI624 and OMNI848 ONLY)
To arm or disarm other partitions from your keypad, enter the following:
#
0
[1-3, 0, 9]
where: 1-3* = the desired partition you wish to change to
When you enter a partition number (1-3*), the system displays the
current armed state for that partition. You can then arm or disarm
the partition by entering the arming/disarming command.
0 = arms all partitions
9 = disarms all partitions
* Partition 3 is available on the OMNI848 ONLY.
SET AUTO-ARM TIME
Set Auto-Arm Time lets you set the time your system will automatically arm.
To set the Auto On Time:
Press
#
+
5
+
4
+ user code + hour 00-23 + minute 00-59.
The keypad will prompt you for the required entries.
TO VIEW AUTOARM TIME
To view the autoarm time for the partition to which the keypad is assigned, press:
#
+
5
+
2
+ user code with authority level 1 or 2.
AUTOARM TIME:
05:00PM
(The user code is not required if so programmed by installer.)
DOOR STRIKE
To activate door strikes:
Press
#
+
5
+
7
+ Door No.
If programmed, certain user codes can also be used to open a door. See your installer
for door numbers.