Filter
Top Products
- 13 -
Arming the System (cont)
TO BYPASS A ZONE
The Bypass function excludes a zone of protection from the security system until it
is unbypassed (either by using the unbypass procedure or when you disarm the
system). Bypassing can only be done while the system is disarmed.
NOTE: 24-hour zones may be bypassed, but can only be unbypassed if the zone is
not faulted (condition has been cleared).
Press the BYPASS/
button. Then enter your user code and the zone number
to be bypassed, as follows:
BYPASS
/
followed by your user
code
†
+ Zone
No.
†
If the Quick Bypass feature has been enabled by the installer, do not enter the
user code when bypassing zones.
NOTE: Bypassed zones are NOT protected when the system is armed. After the
bypass command has been accepted, the keypad sounds one long beep, and the
following is displayed:
LCD Keypad:
BYPASSED: ZN 01
FRONT DOOR
Fixed-Word Keypad:
BYPASS/
Zone number displayed
LED Keypad:
Zone LEDs of the zone(s)
bypassed slowly blink
To Bypass multiple zones, within 10 seconds of the BYPASS/ + User Code +
Zone No. entry, enter:
BYPASS
/
+ Zone No.
This command can be repeated for each zone to be bypassed.
TO UNBYPASS A ZONE
Pressing the BYPASS/
button returns a bypassed zone to normal operation.
To unbypass a zone, the system must be disarmed. (Also note that 24-hour zones
cannot be unbypassed if they are faulted.) To unbypass a zone(s), repeat the bypass
function as follows:
BYPASS
/
followed by your user
code
†
+ Zone
No.
†
If the Quick Bypass feature has been enabled by the installer, do not enter the
user code when unbypassing zones.
After unbypassing, the zone display will show the state of the zones.