Filter
Top Products
- 15 -
User Codes
TO ADD OR CHANGE A USER CODE
Users can be added or changed directly at the keypad. Your system can have up to
15 (OMNI400 and OMNI600), 32 (OMNI624), or 64 (OMNI848) different user codes,
with each assigned to one of four authority levels and to a primary partition
(OMNI624 and OMNI848 only). The authority level determines the functions that
user can perform. In addition, your system can be set up for 4-digit or 6-digit user
codes. Ask your installer which type of user codes is used in your system.
To add or change a user code, press the following:
CODE
/
+
Master User Code User ID* New User Code Auth. Level
nn [1-4]
* Valid User ID numbers are 01–15 for the OMNI400 and OMNI600, 01–32 for the
OMNI624, or 01–64 for the OMNI848.
Authority Levels
Level Functions Allowed
1 Primary Master: access all partitions; can view log and set time; assign other user
codes; all system functions
2 Secondary Master: same as primary master except cannot change the primary
master’s code
3 User: cannot assign codes and cannot bypass zones
4 Limited user: same as level 3, except can disarm the system only if it was armed by
another user with level 4 authority (cannot disarm if armed by user of higher authority
level).
ASSIGNING PARTITIONS TO USERS (OMNI624 and OMNI848 ONLY)
When a user code is assigned, that user is automatically allowed to perform system
functions in the partition in which the user’s code is assigned. You can also allow
users to access other partitions and turn on open/close reporting to a pager by using
the #7 command as follows:
#
7
[master user code] [user no.] [1, 2, 3*, or 4]
where: master user code = user with authority level 1 or 2
user no. = the user that will be assigned access to other partitions
1, 2, 3, or 4 = enter the partition(s) 1-3* you want this user to have access
to; enter 4 if you want this user to send open/close reports to a pager
* Partition 3 is available on the OMNI848 ONLY.