Honeywell 400 Home Security System User Manual


 
- 3 -
Quick Reference
TO ARM THE SYSTEM
1. Check to make sure the system is ready. (The Green READY light is lit.)
2. Enter your 4-digit (or 6-digit) user code.
The ARMED/ light will light.
3. Exit through a door designated by your installer as an exit/entry door.
NOTE: If you DO NOT EXIT during the exit time and your system installer has
programmed your system for Auto-Stay, the system will arm in the Auto-Stay
mode.
TO DISARM THE SYSTEM
1. Enter through a door designated by your installer as an exit/entry door.
2. Enter your 4-digit (or 6-digit) user code.
The ARMED/ light will go out.
TO ARM THE SYSTEM AND STAY INSIDE
1. Check to make sure the system is ready. (The Green READY light is lit.)
2. Press
STAY
/ .
3. Enter your 4-digit (or 6-digit) user code.
The ARMED/ light and STAY/ light will both light.
REMEMBER: Unless the Quick Exit feature is enabled, you must disarm the
system if you want to open the door or leave the premises after the exit time has
passed.
TO ARM THE SYSTEM IN INSTANT MODE, AND STAY INSIDE
1. Check to make sure the system is ready. (The Green READY light is lit.)
2. Press
INSTANT
/ .
3. Press
STAY
/ .
4. Enter your 4-digit (or 6-digit) user code.
The ARMED/ light, the INSTANT/ light, and the STAY/ light will all be
lit.
TO RESET SMOKE DETECTOR
1. Enter your 4-digit (or 6-digit) user code twice.