Filter
Top Products
- 17 -
Miscellaneous Commands (cont)
QUICK BYPASS
If you have Quick Bypass programmed for your system, you can bypass zones
without entering your user code. The Quick Bypass procedure is:
BYPASS
/ 2-digit Zone No. (e.g., 01 for zone 1)
NOTE: Bypassed zones are not protected when the system is armed. After the
bypass command has been accepted, the keypad sounds one long beep. The zone
light of the bypassed zone(s) slowly blinks, or the display shows:
LCD Keypad:
BYPASSED: ZN1
Fixed-Word Keypad:
BYPASS/ LED lit
LED Keypad:
Zone light of the bypassed
zone(s) will slowly blink
NOTE: Temporary users (e.g., babysitters, housekeepers, etc.) should not be shown
the Bypass procedure.
QUICK EXIT
Quick Exit restarts the exit delay time if the system is already armed. This allows
someone to leave after the system has been armed, without having to disarm the
system first.
To restart the exit delay time, press:
STAY
/
TURN CHIME ON/OFF
Chime is an optional feature that causes the keypad to beep when selected doors
are opened while the burglary protection is off or disarmed.
Only your installer can program a zone for the Chime feature, but once
programmed, you can turn Chime on or off to meet your daily needs.
To turn Chime on or off: Press
#
, then
6
.
ASSIGN USERS ACCESS TO OTHER PARTITIONS (OMNI624 and OMNI848 ONLY)
You can assign users access to any of the partitions in a multi-partition system by
entering the following:
#
7
[master code] [user number] [1, 2, 3*]
where 1, 2, 3* are the partitions to which the user is authorized to access.
* Partition 3 is available on the OMNI848 ONLY.