Honeywell 400 Home Security System User Manual


 
- 20 -
Miscellaneous Commands (cont)
DISPLAY ZONE DIRECTORY (LCD KEYPADS ONLY)
To view a list of the zones in the current partition, press
#
+
4
. The
zones will automatically scroll.
USER LOG VIEW (LCD KEYPADS ONLY)
To view the system log, press:
#
+
5
, +
3
+ user code.*
(*The user code is not required if so programmed by installer.)
When the command is accepted, the display will show the most recent event.
Pressing either
STAY
/ or exits this mode.
Pressing any other key advances to the next valid log entry.
KEY FOB LOW-BATTERY TEST (OMNI624 and OMNI848 ONLY)
To activate the key fob low-battery test:
Press :
#
then
5
+
6
The test mode is indicated as follows:
LCD Keypad:
Keyfob Bat. Test
#56 =Exit
Fixed-Word Keypad:
AC
FO TEST
LED Keypad:
An acknowledgement tone is
sounded.
When a keyfob button is pressed, the system will provide a display indicating if the
keyfob has a low-battery condition.
The system exits this mode when the star
key is pressed.
KEYPAD BACKLIGHT TIMER
If you are using an OMNI-KP, OMNI-KP-US, OMNI-LCD, or OMNI-LCD-US
keypad, these keypads have a timer controlled keypad backlight that is on for 120-
seconds following a key press (timer on) or constantly on (timer off).
To change the backlight timer:
OMNI-KP or OMNI-KP-US: Press the
INSTANT
/ and
CODE
/ keys
at the same time and hold down for two seconds until you hear a beep. Pressing the
1
key toggles a zero or one in the display.
0 = Timer off (backlight always on)
1 = Timer on (backlight on for 120-seconds following key press)
Press the
key to exit this Backlight menu.