Filter
Top Products
-6-
How to empty the dust compartment
1) Empty the dust compartment before dust reaches the max line.
2) If you continue using the cleaner, the suction power will be diminished due to dust
clogging the filter.
3) Please remove the dust.
NOTE:
Switch off the power and remove the mains plug from the socket before emptying the
dust compartment.
How to dispose of the dust (Fig. 17)
1) Press the clamp of dust case.
2) Remove the dust case from the lower side.
NOTE:
1) When you remove the dust compartment from the body, don't press the open button
on the compartment. If you do so, the dust will spill out from the compartment.
2) When using the cleaner, don
't remove the dust compartment from the body.
3) Be careful when removing the dust compartment not to spill dust.
4) Put the whole dust compartment into a poly bag and press the open button to empty
dust into the poly bag.
5) Turn the dust compartment downwards, push the open button for the lid of the
dust compartment, to release the dust.
6) Remove dust around the mesh filter and under mesh filter.
Filter care (Fig. 18)
It is recommended that the filter is cleaned once or twice
a month to ensure optimum suction power:
1) Empty the dust compartment as described in the
previous section.
2) Take off the filter supporter from the filter holder.
3) Wash the filter in tepid water or a neutral detergent.
If detergent is used, rinse it out thoroughly.
4) Allow the filter to dry naturally.
NOTE:
1) Don't wash in boiling water or in a washing machine.
2) Don't dry over a fire, in hot sunlight or in a tumble dryer.
3) If the filter is used when wet, suction will be impaired and the motor may be
damaged.
Filter
Holder
Filter
Supporter
Filter
Fig.18
Button
Mesh Filter
Poly Bag
Fig.17
Clamp
Max line
Dust compartment
CV_90CY.p65 6/28/04, 3:23 PM7