Filter
Top Products
-10-
IMPORTANT
The mains lead on this equipment is supplied with a moulded plug
incorporating a fuse, the value of which is indicated on the pin face of the
plug. Should the fuse need to be replaced, an ASTA or BSI approved
BS 1362 fuse must be used of the same rating. If the fuse cover is
detachable never use the plug with the cover omitted. If a replacement
fuse cover is required, ensure it is of the same colour as that visible on the
pin face of the plug. Fuse covers are available from your dealer.
DO NOT cut off the mains plug from this equipment. If the plug fitted is
not suitable for the power points in your home or the cable is too short to
reach a power point, then obtain an appropriate safety approved extension
lead or consult your dealer.
Should it be necessary to change the mains plugs, this must be carried out
by a competent person, preferably a qualified electrician.
If there is no alternative to cutting off the mains plug, ensure that you
dispose of it immediately, having first removed the fuse, to avoid a possible
shock hazard by inadvertent connection to the mains supply.
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Blue=Neutral, Brown=Live
As these colours may not correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:
The wire coloured BLUE must be connected to the terminal marked with
the letter N or coloured BLUE or BLACK. The wire coloured BROWN must
be connected to the terminal marked with the letter L or coloured BROWN
or RED.
On no account connect either of these wires to the terminal marked E or by
the earth symbol or coloured green or green and yellow.
THIS PRODUCT CONFORMS WITH THE
REQUIREMENTS OF THE FOLLOWING COUNCIL DIRECTIVES:
EMC: 89/336/EEC. LVD: 72/33/EEC, AND MARKING 93/68/EEC.
CV_90CY.p65 6/28/04, 3:23 PM11