Filter
Top Products
TIPS ON REAR PANEL CONNECTIONS
26
• S-VIDEO, YPbPR, IEEE 1394 or HDMI connections are provided for high performance laserdisc players, VCRs etc. that have
this feature. Use these connections in place of the standard video connection if your device has this feature.
• If your device has only one audio output (mono sound), connect it to the left audio jack on the AVC Center.
• Refer to the operating guide of your other electronic equipment for additional information on connecting your hook-up cables.
•Asingle VCR can be used for VCR #1 and VCR #2, but note that a VCR cannot record its own video or line output (INPUT: 4 in
the example on page 25). Refer to your VCR operating guide for more information on line input-output connections.
• Connect only 1 component (VCR, DVD player, camcorder, etc.) to each input jack.
• COMPONENT: Y-P
B
P
R
(Input 1 & 2) connections are provided for high performance components, such as DVD players and set-
top-boxes. Use these connections in place of the standard video connection if your device has this feature.
•Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the TV’s P
B
input
and the components R-Y output to the TV’s P
R
input.
•Your component outputs may be labeled Y-C
B
C
R
. In this case, connect the components C
B
output to the TV’s P
B
input and the
components C
R
output to the TV’s P
R
input.
• It may be necessary to adjust TINT to obtain optimum picture quality when using the Y-P
B
P
R
inputs. (See page 55)
•To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the
Y-P
B
P
R
, RGB and HDMI input
jacks.
• Input 1 or 2 can accept HDMI signal.
• Input 1 or 2 can accept both component and composite video signal.
• S-VIDEO monitor output may be used for recording only when the input is of S-VIDEO type.
• When using a DVI or HDMI input from a Set-Top-Box, it is recommended to use a 1080i or 720p input signal.
FIRST TIME USE