Filter
Top Products
:The air conditioner starts at the set time.
The air conditioner stops at the set time.
:The air conditioner makes the room warm
:The air conditioner reduces the humidity in the room.
direction to one of the six possible
positions manually, or to select the
The airflow direction can be set manually.(six positions)
:The flap moves up and down automatically.
:Press the FLAP button and set the airflow directions as desired. (refer to Adjust the
Airflow Direction).
:
Use this button to select AUTO, HEAT, DRY, COOLING or FAN mode.
:When this setting is selected, the air conditioner calculates the difference between the
set thermostat and the room temperature and automatically switches to the "COOLING"
or "HEATING" mode appropriately.
:The air conditioner makes the room cool.
:He air conditioner makes the room's temperature suitable.
Press this button either to select to set the airflow
sweep function, which moves the flap up and down
automatically.
:
:The air conditioner automatically decides the fan speeds.
: High fan speed.
:Medium fan speed.
:Low fan speed.
:When you press this button, regardless of whether the unit is operating or stopping,
the unit operates for one hour and then shuts down.
Puts the remote control unit into pre-operation status. Always press this button after
replacing the batteries.
When you press this button (use a small-tipped object such as a ballpoint pen), the mark
will appear at the display. And the room temperature is detected by the sensor which is built
into the indoor unit and the air conditioner is controlled accordingly.
If the remote control unit is located near a heat resource, press the A/C sen-
sor button to switch to the sensor in the indoor unit.
When you press this button, you can limit the maximum electric current, so that you can use
it with other electric instrument when power is not enough.
!
NOTE
TIMER ON button
MODE selector button
(AUTO)
(HEAT)
(DRY)
(COOL)
(FAN)
FLAP button
FAN SPEED selector
button
1 HR TIMER button
(1-HOUR OFF TIMER)
ACL button
SOFT button
TIMER OFF button
TIMER SET/CANCEL button
A/C SENSOR button
7
Remote Control Unit(continued)
This button is used to set/cancel the time at which you wish the air conditioner to go on or off.
AUTO
AUTO
AUTO
1HOUR1HOUR
Automatic switching between cooling and heating
this unit automatically switches between cooling operation and heating operation according to the difference
between the room temperature and the set temperature.
NOTE
The remote control unit sends temperature signal to the air conditioner regularly at three
minutes intervals. If the signal from the remote control unit stops for more than ten minutes
due to the loss of the remote control unit or other tyouble, the air conditioner will switch to the
temperature sensor which is built into the indoor unit and control the room temperature. In
theses cases, the temperature around the remote control unit may differ from the temperature
,
detected at the air conditioner s position.