Filter
Top Products
MHP-TN USER INSTRUCTIONS ENGLISH 71576313 - 02/07
Page 27 of 28 flowserve.com
8.2 Sectional drawings part list
ITEM DESIGNATION
1110 Pump casing
1221 Casing cover with stuffing box
1500 Wear ring
2110 Pump shaft
2250 Radial flowimpeller
2450 Shaft sleeve
2540 Thrower
2905 Plain washer
2912 Self-braked nut
3011 Radial ballbearing
3134 Support foot
3200 Bearing housing
3260 Bearing cover
3300 Bearing bush
4120 Gland
4130 Gland packing
4132 Stuffing box neck bush
4590-01 Gasket
4590-02 Gasket
4590-03 Special ring
6511 Primingplug
6515 Drainplug
6544 Bore circlip
6569 Screwed plug
6572 Stud
6577-01 Hexagon bolt
6577-02 Hexagon bolt
6577-03 Hexagon bolt
6581 Hexagonnut
6700-01 Key
6700-02 Key
9331 Cover plate
8.3 General arrangement drawing
The typical general arrangement drawing and any
specific drawings required by the contract will be sent
to the Purchaser separately unless the contract
specifically calls for these to be includedinto the User
Instructions. If required, copies of other drawings
sent separately to the Purchaser should be obtained
from the Purchaser and retained with these User
Instructions.
9 CERTIFICATION
Certificates determined from the Contract
requirements are provided with these instructions
where applicable. Examples are certificates for CE
marking, ATEX marking etc. If required, copies of
other certificates sent separately to the Purchaser
should be obtained from the Purchaser for retention
with these User Instructions.
10 OTHER RELEVANT
DOCUMENTATION AND MANUALS
10.1 Supplementary User Instructions
Supplementary instructions such as for a driver,
instrumentation, controller, seals, sealant system etc
are provided as separate documents in their original
format. If further copies of these are required they
should be obtained from the supplier for retention
with these User Instructions.
10.2 Change notes
If any changes, agreed withFlowserve, are made to the
product afterits supply, a record of the details should
be maintained with these User Instructions.
10.3 Additional sources of information
Reference 1:
NPSH for Rotor dynamic Pumps: a reference guide,
Euro pump Guide No. 1, Euro pump & World Pumps,
Elsevier Science, United Kingdom, 1999.
Reference 2:
Pumping Manual, 9
th
edition, T.C. Dickenson,
Elsevier Advanced Technology, United Kingdom, 1995.
Reference 3:
Pump Handbook, 2
nd
edition, Igor J. Karassik et al,
McGraw-Hill Inc., New York, 1993.
Reference 4:
ANSI/HI 1.1-1.5, Centrifugal Pumps - Nomenclature,
Definitions, Application and Operation.
Reference 5:
ANSI B31.3 - Process Piping.