Filter
Top Products
22
Getting Started
Changing the Instrument Settings
Jitter Mask Selection
Graphical displays of jitter mask selections are available. The current
settings are shown by a marker on the graphical display.
Jitter Mask set to Off
To obtain a graphical display, move the cursor to RANGE,
MODULATION FREQUENCY, or AMPLITUDE and press .
To change a value, use and to select the parameter you
want to change, RANGE, MOD FREQ OR AMPLITUDE.
Press for a pop-up menu.
Make your selection from the pop-up menu as described in Modifying
Displays with Pop-up Menus page 16 and press again to select the
new value.
The marker on the graphical display will move to the new position and
set the new value.
To exit the graphical display with the new value set, press .
SET
SET
SET
CANCEL
SET