Filter
Top Products
INSTALLATION INSTRUCTIONS FOR
INSTALLING A ROTARY VALVE UNIT
REMOTE CONTROL
1. Refer to pages 4 and 5 of these instructions for installation of the burner unit and logs.
2. The remote control package has a hand held transmitter and a receiver with wires attached to it.
NOTE: The receiver requires 4 AA batteries (not included) and the transmitter requires one 9 volt
transistor battery (not included). Do not install the batteries until all hookups are completed.
3. Remove the receiver and locate the two female terminals on the end of the wires. One of
these terminals is smaller than the other one.
4. Locate the two male terminals on the top right front of the valve.
5. Plug the small female terminal from the receiver on the small male terminal of the valve.
6. Plug the larger female terminal from the receiver on the larger male terminal of the valve.
7. It is best to place the receiver in the fireplace as far away from the burner unit as possible
to protect it from heat. Make sure the receiver eye is facing the room so it can receive the
signal from the transmitter.
8. Install batteries in the receiver by removing the back of the receiver where the wires go in.
9. Install the battery in the hand held transmitter by removing the back of the unit.
10. Follow LIGHTING INSTRUCTIONS on page 9 to light the pilot on your log set, and then follow item 6 under
LIGHTING INSTRUCTIONS on page 9 to turn on your main control knob. CAUTION: Y
our log set may come on
when you complete this step.
11. You can now operate your log set with the hand-held transmitter.
12. Push and hold the "ON" button of the transmitter to turn on the log set.
13. Push and hold the "OFF" button of the transmitter to turn off the log set.
WALL SWITCH
1. Refer to pages 4 and 5 of these instructions for installation of the burner unit and logs.
2. It is recommended that a qualified electrician do the installation.
3. The wall switch kit has a wall switch and cover and is designed to be installed in a
standard wall switch box. NOTE: The wall switch requires 4 AA batteries (not included).
Do not install the batteries until all hookups are completed.
4. There must be two wires run from the switch box to the interior of the fireplace. If the wire
furnished with the wall switch is not long enough, an electrician must run the correct length of
wire.
5. It is very important to connect the wires correctly between the wall switch and the valve.
There is a small male terminal and a large male terminal located on the valve and there are two terminals on the
back of the wall switch. (NOTE: The terminals on the wall switch are labeled 1/4” and 3/16”.) Connect the wires
from the small male terminal on the valve to the terminal marked 3/16” on the wall switch, and the large male
terminal on the valve to the terminal marked 1/4” on the wall switch. It is very important not
to get the wires crossed when making this connection.
6. After all connections are made, install the batteries and secure the switch and cover at the
wall switch box.
7. Follow LIGHTING INSTRUCTIONS on page 9 to light the pilot on your log set, and then follow item 6 under
LIGHTING INSTRUCTIONS on page 9 to turn on your main control knob. CAUTION: Your log set may come on
when you complete this step.
8. You can now operate your log set with the wall switch.
9. Push and hold the "up arrow" on the wall switch to turn on the log set.
10. Push and hold the "down arrow" on the the wall switch to turn off the log set.
OPERATION OF THE REMOTE CONTROL AND WALL SWITCH
The remote control and wall switch only operates when you are holding the "ON" or "OFF" button down. You can turn the
log set up and down or turn the log set on and off. When you are depressing the "ON" and"OFF" button, watch the flame on
your log set and release the button when the log set is at the desired flame height.
10