Filter
Top Products
60
Heatilator • HEIR36, HEIR42, HEIR50 • 2285-900 Rev. D • 8/12
Figure 14.4. Glass Clip Tool Location
Figure 14.5 Inserting Glass Clip Tool
Figure 14.3. Glass Clip Tool
H. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
WARNING! Risk of Injury! Glass assembly installation
and removal must be performed by a qualifi ed service
technician. See chart below for glass assembly weights.
• HEIR42 AND HEIR50 MODELS: It is recommended
that Glass installation and removal be performed by
two qualifi ed service technicians.
CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation. Sheet metal
edges are sharp.
Removing Fixed Glass Assembly
This fi xed glass assembly is held in place by lower glass
clips, side clips and top retaining rail. To remove clips, en-
gage the spring clips with the tool and pull tool out slightly.
1. The glass clip removal/installation tool is fastened to
the lower right corner of the fi replace. Remove tool
by removing one screw. See Figure 14.3. If glass clip
removal tool becomes misplaced, a cotter pin removal
tool may be used. Replace glass clip removal/instal-
lation tool in same place with the one screw after use.
2. To disengage bottom glass clips, position the glass
clip removal/installation tool parallel to the fl oor and
insert it about two inches into the gap between the
glass frame and the front bottom fi replace lip. Insert
the tool on the lower left side of the glass clip and
move to the right to engage the clip. Using one mo-
tion, pull out slightly while pushing down to disengage
bottom glass clip. Repeat for the other bottom spring
clips. There are three on the HEIR36 and four on the
HEIR42 and HEIR50. See Figure 14.5.
3. Disengage the left and right glass clips one at a time
using the glass clip removal/installation tool. Insert
tool from the top side of the side glass clip. Pull the
glass tool out slightly to disengage the side clip. See
Figure 14.9.
4. Grasp the left and right sides of the glass assembly
and carefully pull outward to remove the bottom from
the support tabs on the bottom glass clips. Lower the
glass to remove it from the top retainer rail.
NOTICE: Protect and prevent the hearth from damage by
covering it with a drop cloth.
Glass Weights
HEIR36 HEIR42 HEIR50
32 lbs 41 lbs 54 lbs
CAUTION! Risk of Injury! DO NOT put fi ngers under
glass frame. Fingers may get pinched by glass frame
during removal.