Filter
Top Products
6 598-1347-00
CAUTION: To Avoid Fire Or Burn Hazards:
• Allow xture to cool before touching. The bulb and the xture
operate at high temperatures.
• Keep xture at least 2" (51 mm) from combustible materials.
Do not aim at objects closer than 3' (1 m).
• Replacement Bulb - Use only T4 100W (max.), G8 tungsten
halogen bi-pin 120 VAC bulbs.
CAUTION: Keep the sensor at least 2" (51 mm) away
from the bulbs.
HALOGEN FLOODLIGHT
Features and Ratings:
• Up to 200 Watt Maximum Tung-
sten Halogen (Up to 100 Watt
Maximum each bulb holder.)
• Minimal wiring required.
• Bulb Saver™ - Extends bulb life by up to 4x standard bulbs.
Lights bulb to full bright in under 2 seconds.
• Install xture in accordance with local codes.
Bulb Installation and Replacement
Note: Bulbs are included, but you will need to install them.
Note: When replacing bulbs, turn power off and let the xture
cool.
• To remove lamp shade, loosen set screw 2 full turns with a
small at-head screwdriver. Turn shade counterclockwise and
remove.
• To remove bulb, pull straight out of xture.
• To replace bulb, push bulb pins into bulb socket. Check that the
bulb is seated properly.
• To reinstall lamp shade, place shade on xture and align notches
on shade with tabs on xture. Turn clockwise. Tighten set screw
rmly.
INDOOR PLUG-IN CONVERTER
Features and Ratings:
• Up to 300 Watt maximum incandescent load.
• No wiring required.
1. Plug in indoor receiver.
2. Plug in light you wish to control.
Control Locations
Remote
By-Pass
Switch
Alarm Volume
ControlSpeaker
RECEIVER INFORMATION
All receivers have the following features and ratings:
• Rated for 120VAC/60Hz supply voltage.
• Not for use with Compact Fluorescent bulbs.
• When rst turned on wait 15 seconds.
CAUTION: Do not exceed the maximum load limits
listed above.
3. Check operation. Activate transmitter being used with receiver
(see transmitter instructions). A signal will be sent to the receiver
to turn the receiver ON or OFF.
4. Using Remote By-Pass Switch. These receivers are equipped
with a remote by-pass switch. This switch allows the user to
select between AUTO and MANUAL modes. AUTO mode
allows the light to be operated by remote control or remote
motion sensor. MANUAL mode allows the plugged in light to
be operated manually.
5. Adjust audio alert volume. The alarm sounds only when the
receiver is activated by the wireless motion sensor and entry
switch. The alarm volume is adjusted by the thumbwheel on
the side of the receiver unit.