Heath Zenith 598-1347-00 Indoor Furnishings User Manual


 
4 598-1347-00
RANGE
ON-TIMEDUALBRITE™
MAX
DUSK TO
DAWN
TEST 1 5
(MINS)
6 3
HRS
OFF
MIN
Check Operation and Adjustment
Note: When rst turned on or when switching modes wait 30
seconds.
Note: Meets the ENERGY STAR
®
guidelines when DualBrite
®
function is off.
Locate the RANGE control and ON-TIME control on the motion
sensor:
• The RANGE control and ON-TIME control are located on the bottom
of the motion sensor. Using your ngernails or a small, at-head
screwdriver, gently pry the cover until it opens.
1. Check Operation. Set the ON-TIME control to TEST mode. Walk in
front of motion sensor. The LED indicator light should ash when
motion is detected (see illustration for location of LED light).
2. Adjust Motion Sensor. Turn the RANGE control to the mid posi-
tion and ON-TIME control to the TEST position. Walk through
coverage area noting where you are when the LED begins to
ash. Loosen the clamp screw and move the motion sensor to
change the coverage area. Tighten clamp screw when nished.
Do not overtighten clamp screw.
3. Adjust RANGE Control. To increase sensitivity, turn the RANGE
control toward MAX. To decrease sensitivity, turn the RANGE
control toward MIN. Note: If the RANGE is set too high, false
triggering may result in some environments.
Note: When using test mode to check operation in the day time:
A. Set the DETECT control switch to DAY/NIGHT and
B. Set the ON-TIME control to TEST.
5 1 TEST
ON-TIME
(MINUTES)
RANGE
MAX
MIN
180° Motion Sensor Controls
240° Motion Sensor Controls
4. Set ON-TIME Control. Determine the amount of time you want
the connected device to stay on after motion is detected (1 or
5 minutes). Slide the ON-TIME control to the corresponding
setting.
DualBrite
®
Dimmer Control
(240° Motion Sensor Only)
Light comes on half power for selected time after dusk (Off, 3 or
6 hours, until dawn). When motion is sensed, the light turns on
full power for the selected ON-TIME (1 or 5 minutes) then returns
to accent mode.
1.
Select amount of time desired for accent lighting (DualBrite
®
control).
Off
3 Hours
6 Hours
Dusk to Dawn
IMPORTANT: Avoid Aiming Motion Sensor At:
• Objects that change temperature rapidly, such as heating vents,
fans, and air conditioners. These air sources could cause false
triggering.
• Areas where pets or trafc may trigger the control.
• Nearby large, light colored objects reecting light may trigger the
shut-off feature. Do not point other lights at motion sensor.
LED
Indicator
LED Indicator
Range
Control
Range
Control
ON-TIME
Control
ON-TIME
Control
D
ualBrite
®
Control