Heath Zenith 598-1000-07 Door User Manual


  Open as PDF
of 24
 
-2-
598-1000-07
4. Test range. Temporarily position chime and push but-
ton where you want it mounted. Press push button to
verify chime and push button work properly. If chime
does not sound, see Troubleshooting.
5. Adjust volume control. Adjust volume control to
desired volume (see Figure 3).
6. Mount push button. Use either screws or double
sided tape to mount push button.
• ScrewMounting:To mount with screws, remove
back of case by pushing in tab on bottom with a
small screwdriver (see Figure 1). Note: Remove
material in screw holes (if needed) before mounting
with screws. Attach back of case to door jamb or wall
(see Figure 4). Snap front of push button on.
• Tape Mounting:Whenattachingpushbuttonusingdoublesidedtape,
make sure the surface of the door jamb or wall is clean.
7. Mount chime. Determine mounting location.
The chime base can be mounted in two different ways. The base can be mounted
using one keyhole and one mounting hole or two mounting holes. The base
may be mounted horizontally or vertically depending upon the specific model
purchased.
Keyhole Mounting:
• Removebatteriesfromchime.
• Drillone7/32"diameterpilotholeforkeyholewallanchorandinsertanchor.
Note:Keyholeslotislocatedabout1"(25mm)fromtopofchime.
• Mountkeyholescrewtowallleavingabout1/8"(3mm)ofthescrewthreads
exposed (see Figure 5).
• Usingkeyholeonbackofchimebase,hangbaseonscrew.
• Levelchimebase.
• Usingthehorizontalslotlocatedinthebottomofthebatterycompartment,
mark location for second screw.
• Drillone7/32"diameterpilotholeforwallanchorandinsertanchor.
• Insertsecondscrewthroughthehorizontalslotandattachtowall.
• Verifychimeislevelandtightenscrewssecurely.
• Replacebatteries(seeFigure3).
• SnapcoverontochimeasshowninFigure7.
Figure 4
 previous next