Heat & Glo LifeStyle Escape-42DV Indoor Fireplace User Manual


 
Heat & Glo • Escape-42DV • 2052-900 Rev. Y • 11/11 47
A. Remove Fixed Glass Assembly
See Section 14.G.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the fi rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
E. Ember Placement
WARNING! Risk of Explosion! Follow ember placement
instructions in manual. DO NOT place embers directly over
burner ports. Replace ember material annually. Improperly
placed embers interfere with proper burner operation.
Ember material is shipped with this gas appliance. To place
the ember material:
• Remove the ash lip that is located in front of the glass.
• Remove the side panels located in front of the glass.
• Remove the pull mesh fi rescreen by unhooking from the
fi replace.
• Pull and release the six glass latches (3 per side) located
on the sides of the glass frame.
• Grasping the upper lip with one hand and the lower
lip with the other, pull the bottom of the glass out fi rst.
Guide the bottom while letting the top drop down under
the top of the opening (see Section 14.G Fixed Glass
Assembly).
• There are two types of ember shipped with the unit.
Embers for the burner surface and Mystic Embers for
the fl oor of the unit.
• Do NOT place embers between log #3 and log #4. They
may disrupt the fl ames and are not visible.
• Place Mystic Embers on the fl oor of unit. Use Mystic
Embers to hide the pilot wires on left side of the
burner.
NOTICE: Do NOT place Mystic Embers over lighted area
of lens. Lens may melt if covered.
• Save the remaining ember materials for use during
fi replace servicing.
14
Appliance Setup