Filter
Top Products
28
!
Follow these steps:
1. Release four glass clips and set the
glass assembly aside.
CAUTION: The log assembly is
fragile. Handle with care.
NOTE: See Step 9 when replacing
the log set in an existing fireplace.
2. Carefully cut the cable tie holding the
log assembly in place and discard the
tie. Do
not leave any part of the tie in
the fireplace (see Figure 35).
WARNING: USE WIRE CUT-
TERS. DO
NOT ATTEMPT
TO CUT THE TIE WITH A
KNIFE.
3. Grasp the log assembly by the
ends. Do
NOT grasp the log as-
sembly by the center. Remove the
log assembly from the fireplace and
set aside.
4. Remove the foam pad from the fire-
place and discard. Make sure all piec-
es of the foam are removed. With a
screwdriver bend up the log place-
ment tabs (see Figure 36).
Figure 34
Figure 36
Figure 35
BEFORE
FIRING THE UNIT
!
Log Placement Tabs
Positioning the Logs