Filter
Top Products
17Heat & Glo • 8000TV-OAK, 8000TV-OAK-IPI, 8000TVLP-OAKIPI • 2058-900 Rev. L • 08/08
Figure 7.3 Proper Positioning, Leveling and Securing of a
Appliance
NAILING TABS
(BOTH SIDES)
Fire Risk.
• ALWAYS maintain specifi ed
clearances around the appliance.
• Do NOT notch into the framing around the appliance spacers.
Failure to keep insulation, framing or other material away from
the appliance may cause fi re.
WARNING
Figure 7.6
E. Checking Pilot Plate
D. Completing Grate Set-up
1. Straighten the tabs on the grate bracket (see Figure
7.4) and remove grate from unit.
2. Remove grate bracket (see Figure 7.4) by bending it
back and forth until it breaks. Discard grate bracket.
3. Remove 4 tabs holding base refractory (see Figure 7.4)
by bending tabs back and forth until they break.
Figure 7.5 Re-install grate in unit
Figure 7.4 Removing Grate
Note: Ensure pilot plate is in place. This will ensure pilot
stability (see Figure 7.6)
PILOT
PLATE
RE-INSTALL
INTO THE UNIT
REMOVE GRATE
REMOVE GRATE BRACKET
REMOVE TAB HOLDING DOWN
BASE REFRACTORY (4 PLACES)
STRAIGHTEN TO
REMOVE GRATE
4. Reinstall grate into unit (see Figure 7.5).