Filter
Top Products
7
Heat Controller, Inc. VMH 30/36 SERIES Installation, Operation & Maintenance
Install the outdoor unit on a rigid base to prevent increased noise levels and vibration.
Ensure the air outlet is not blocked by any objects such as plants or walls, etc.
If the installation location is exposed to strong winds, ensure the unit is placed lengthwise along
the wall or provide a switchable baffle to block strong wind gusts from entering the unit.
If suspending the unit with a bracket, follow the bracket manufacturer’s installation instructions.
Use a raised concrete pad or concrete blocks to provide a solid base and level surface - securely
anchor the unit down with bolts
. See table & figure below.
In a snowy area, install the outdoor unit on a raised platform higher than drifting snow.
Seal
Drain elbow connector
Base pan hole
of outdoor unit
(A)
(B)
The pictures of the drain joint may very from the actual
part that come with the unit.
Push the seal onto the end of the drain elbow connector (Fig. A),
then insert the drain elbow connector into the hole in the bottom
of the base pan of the unit (Fig. B) until it makes a click sound
and is firmly in place. Add an additional drain hose to direct the
condensate away from the base of the unit by placing a hose
on the end of the hose barb. This drain hose is not included with
the unit and must be purchased.
2
DRAIN JOINT INSTALLATION
OUTDOOR INSALLATION PRECAUTION
1
NOTE:
Anchor the outdoor unit with a bolt and nut ( 10mm) or tightly and horizontally
on a concrete or rigid mount.
Ø3/8” Ø Ø5/16”(Ø8mm)
Outdoor unit dimension
in(mm)(L1xHxW1)
L2(mm)
20.6in.(523)
W2(mm)
13.4in.(340)
20.9in.(530)
23.6in.(600)
11.4in.(290)
12.6in.(320)
22.1in.(560)
23.2in.(590)
18.9in.(481)
13.2in.(335)
13.1in.(333)
10.9in.(276)
Mounting dimensions
32.3x23.4x13.0
29.9x23.2x11.2
30.5x21.4x12.2
33.3x27.6x12.6
35.4x33.9x12.4
26.4x21.3x9.8
Settlement of outdoor unit
(820x595x330)
(760x590x285)
(775x545x310)
(845x700x320)
(900x860x315)
(670x540x250)
OUTDOOR SECTION