Heat Controller HTD SERIES Heat Pump User Manual


 
Heat Controller, Inc. HTV/HTD/HTH SERIES Engineering Design Guide
6
HT Series Ratings
ARI/ASHRAE/ISO 13256-1
at EWT (Entering Water Temperature)
—HACR circuit breaker in USA only — All fuses class RK-5
—Wire length based on one way measurement with 2% voltage drop
—Wire size based upon 60°C copper conductor and minimum circuit ampacity
HT Physical Data
(2) 14-24 (2) 14x30 (2) 10x30 (1) 16x30 (1) 16x30
(1) 12x30 (1) 20x30 (1) 20x30
Heat Controller GeoMax 2
n
Geothermal Heat Pump Systems
Heating capacities based upon 68°F DB, 59°F WB entering air temperature.
ELECTRICAL - LINE VOLTAGE
ELECTRICAL - LINE VOLTAGE
All eld installed wiring, including electrical
ground, must comply with the National
Electrical Code as well as all applicable
local codes. Refer to the unit electrical
data for fuse sizes. Consult wiring diagram
for eld connections tKat must be made by
the installing (or electrical) contractor. All
nal electrical connections must be made
with a length of exible conduit to minimize
vibration and sound transmission to the
building.
GENERAL LINE VOLTAGE WIRING
Be sure the available power is the same
voltage and phase shown on the unit serial
plate. Line and low voltage wiring must be
done in accordance with local codes or the
National Electric Code, whichever is
applicable.
T
WARNING! To avoid possible injury
or death due to electrical shock, open
the power supply disconnect switch
and secure it in an open position
during installation.
WARNING!
T
CAUTION! UseRnly copper
conductors for eld installed electrical
wiring.Unit terminals are not
designed to accept other types of
conductors.
CAUTION!
Table 4: Electrical Data (Standard Units) HTV/HTD
20
Compressor
Model Voltage
Min/Max
Voltage
QTY RLA LRA
HWG
Pump
FLA
Ext
Loop
FLA
Fan
Motor
FLA
Total
Unit
FLA
Min
Circuit
Amp
Max
Fuse
Size *
024 208/230-60/1 197/254 1 10.7 56.0 0.4 4.0 4.3 19.4 22.1 30
036 208/230-60/1 197/254 1 17.0 87.0 0.4 4.0 4.3 25.7 30.0 45
048 208/230-60/1 197/254 1 21.5 100.0 0.4 4.0 7.0 32.9 38.3 50
060 208/230-60/1 197/254 1 27.6 125.0 0.4 4.0 7.0 37.4 43.9 60
*
HACR Circuit Breaker in USA Only
All Fuses Class RK-5
070 208/230-60/1 197/254 1 27.6 153.0 0.4 4.0 7.0 39.0 45.9 70
HT Electrical Data
Min.
AWG
Max.
Ft.
10 86
8 63
8 78
6 108
6 101
Supply Wire
Two-Stage Scroll
27.2
154.5
38.6
45.4
36x25
ECM Variable Speed
5
HT Series Ratings
ARI/ASHRAE/ISO 13256-1
at EWT (Entering Water Temperature)
—HACR circuit breaker in USA only — All fuses class RK-5
—Wire length based on one way measurement with 2% voltage drop
—Wire size based upon 60°C copper conductor and minimum circuit ampacity
HT Physical Data
(2) 14-24 (2) 14x30 (2) 10x30 (1) 16x30 (1) 16x30
(1) 12x30 (1) 20x30 (1) 20x30
Heat Controller GeoMax 2
n
Geothermal Heat Pump Systems
Heating capacities based upon 68°F DB, 59°F WB entering air temperature.
ELECTRICAL - LINE VOLTAGE
ELECTRICAL - LINE VOLTAGE
All eld installed wiring, including electrical
ground, must comply with the National
Electrical Code as well as all applicable
local codes. Refer to the unit electrical
data for fuse sizes. Consult wiring diagram
for eld connections tKat must be made by
the installing (or electrical) contractor. All
nal electrical connections must be made
with a length of exible conduit to minimize
vibration and sound transmission to the
building.
GENERAL LINE VOLTAGE WIRING
Be sure the available power is the same
voltage and phase shown on the unit serial
plate. Line and low voltage wiring must be
done in accordance with local codes or the
National Electric Code, whichever is
applicable.
T
WARNING! To avoid possible injury
or death due to electrical shock, open
the power supply disconnect switch
and secure it in an open position
during installation.
WARNING!
T
CAUTION! UseRnly copper
conductors for eld installed electrical
wiring.Unit terminals are not
designed to accept other types of
conductors.
CAUTION!
Table 4: Electrical Data (Standard Units) HTV/HTD
20
Compressor
Model Voltage
Min/Max
Voltage
QTY RLA LRA
HWG
Pump
FLA
Ext
Loop
FLA
Fan
Motor
FLA
Total
Unit
FLA
Min
Circuit
Amp
Max
Fuse
Size *
024 208/230-60/1 197/254 1 10.7 56.0 0.4 4.0 4.3 19.4 22.1 30
036 208/230-60/1 197/254 1 17.0 87.0 0.4 4.0 4.3 25.7 30.0 45
048 208/230-60/1 197/254 1 21.5 100.0 0.4 4.0 7.0 32.9 38.3 50
060 208/230-60/1 197/254 1 27.6 125.0 0.4 4.0 7.0 37.4 43.9 60
*
HACR Circuit Breaker in USA Only
All Fuses Class RK-5
070 208/230-60/1 197/254 1 27.6 153.0 0.4 4.0 7.0 39.0 45.9 70
HT Electrical Data
Min.
AWG
Max.
Ft.
10 86
8 63
8 78
6 108
6 101
Supply Wire
Two-Stage Scroll
27.2
154.5
38.6
45.4
36x25
ECM Variable Speed
5
Horizontal-HTH
Air Coil Dimensions (H x W), in 18 x 31 20 x 35 20 x 40 20 x 45 20 x 45
Standard Filter - 2” Pleated
MERV11, Quantity - in x in
2 - 18 x 18
1 - 12 x 20
1 - 20 x 25
1 - 18 x 20
1 - 20 x 24
2 - 20 x 24 2 - 20 x 24
Weight - Operating, lbs 266 327 416 443 443
Weight - Packaged, lbs 276 337 426 453 453
All units have spring compressor mountings, TXV expansion devices, and 1/2” [12.7mm] & 3/4” [19.1mm] electrical knockouts.
Vertical-HTV & Downow-HTD
HT 024 HT 036
HT 048
HT 060 HT 070
Two Stage Geothermal Heat Pump Systems
Standard Filter - 2” Pleated
HERV11, Quantity - in x in
1 - 24 x 28 1 - 28 x 30 1 - 30 x 32 1 - 30 x 36 1 - 30 x 36