INSTALLATION OVERVIEW
2
The following should be always
observed for safety
....................
3
Installation of indoor, outdoor
unit
................................................
4
Flaring work and connection of
piping
...........................................
6
Connection of piping(Indoor)
......
7
For left rear piping
For right rear piping
Connection of piping(Outdoor)
................................................
12
Connecting the cable between
indoor unit and outdoor unit
......
....................................................
13
Checking the drainage and
Forming the piping
..................
15
Air purging
...............................
17
Charging
...................................
19
Test running
.............................
20
❏ Installation plate
❏Four type "A" screws
❏Connecting cable
❏Pipes: Suction line
................
5/8"
Evaporator line
..........
3/8"
(Refer to page 4)
❏Insulation materials
❏Additional drain pipe
(
Outer Diameter
....
15.5mm(0.61in))
❏Two type "B" screws
❏Level gauge
❏Screw driver
❏Electric drill
❏Hole core drill(ø70mm(2.76in))
❏Flaring tool set
❏Specified torque wrenches
4.2kg
.
m, 6.6kg
.
m
(different depending on model No.)
(Refer to page 10)
❏Spanner......................Half union
❏A glass of water
❏Screw driver
❏Hexagonal
wrench(4mm(0.16in))
❏Gas-leak detector
❏Vacuum pump
❏Gauge manifold
❏Owner's manual
❏Thermometer
❏Holder Remote Control
Installation
Requirements
Required Parts Required Tools
Installation Parts Provided
1. Type "A" screw
2. Installation Plate
3. Type "B" screw
4. Holder Remote Control