Heartland 1903 Stove User Manual


 
8
Oval and SweetHeart:
1. Assemble the bell dampers (Fig. 2) and thread into the
three locations, one at the front in the ash pan door, and
2. Insert a piece of 6” (15 cm) diameter black smoke pipe
(See page 14, “Stovepipe Chimney Connection
Requirements”)
Once the cabinet has been assembled and installed, follow
these few remaining steps:
1. Insert the lift handle( #1361) through the bracket and bolt
it through the hole in the cooking surface with the screw
and locknut.
The handle should be able to pivot freely from this point.
Tighten the nut securely, so it can’t work loose under
normal use.
2. The tool holder (#1440) is used to hang the
lid lifter, poker and scraper. To mount the holder, locate
warming cabinet back. Fasten with the bolts supplied.
3. A pipe damper installation is optional depending on your
supply you with a damper.
assembly of the chimney.
a) Open the front cabinet door.
b) Mark the spot for drilling in the back of the pipe by pushing
the sharp end of the damper rod into the back wall of the
pipe before drilling.
c) Drill a 1/4” (6.35 mm) hole in the middle of the smoke pipe
through the centre of the hole in the back of the cabinet.
d) Follow the instructions that came with the damper and
install the damper inside the cabinet with the handle of
the damper also inside the cabinet.
e) Make sure the damper disc rotates freely inside the pipe.
Figure 2
Bell Damper
Nut
lockwasher
#1361 lift handle installed
on cooking surface
Cooking surface
Lift handle